1. Turn off the Mi MIX2s and remove the card with the card pin. The separated rear shell uses a heat gun or a hair dryer to heat the connection between the glass back cover and the bezel of the Mi MIX2S phone, then uses a suction cup to suck up the screen part from the bottom USB interface, and then uses a pry blade to swipe the screen from the gap to the left and right to open the screen.
2, millet mix2 this machine actually can use the performance or the operation is relatively smooth to do a daily use of the machine is still possible. Only the style is longer, so some are also called spare machines.
3, reliable. Love recyclingFine. Wireless charging technology, which allows users to charge devices without plugging in a cable, has become increasingly popular in recent years. However, not all phones support wireless charging natively. 2, the mobile phone does not have the function method is as follows: you can buy a mobile phone case that supports wireless charging, and install it on the mobile phone, the advantage of this method is simple and convenient, there is no need to replace the mobile phone or disassemble the internal phone, the disadvantage is that it may increase the weight and thickness of the mobile phone, as well as affect the heat dissipation and signal of the mobile phone.
3, self-made wireless charger 1: external module installation steps Stick the module away from MicroUSB interface comparison place. Step Connect the MicroUSB or Lightning port on the module to the phone. Steps If there is double-sided tape on the receiver, you can glue it directly to the back of the phone. If it doesn't come with it, you have to figure it out yourself. Step to select the most appropriate position, be careful not to let the part of the connection line warped phenomenon.
4. First, make sure your phone supports wireless charging. Connect the wireless charging pad and charging head through the data cable. Generally, you only need to ensure that it is above 10W. Place the phone on the charging pad, with the coil usually located near the camera. fillingThere will be a prompt when the power is successful. If your Huawei mobile phone supports wireless charging, after the wireless charger is powered, directly place the mobile phone screen facing up in the center of the charger or the position suggested by the manufacturer to charge it.
1, first remove the waste mobile phone, as shown in the following picture after painstaking welding to the positive and negative wires, a waste charger and headphones, remove their wires.
2, finally is a purchase from the Internet QI standard 1000 mA output noLine charging kit, found a lot on the Internet, most of them are output 500mA, Xiaomi mobile phone and a lot of Samsung mobile phones, line charging is 1000mA, with other 500mA chargers have no response, so 500mA is not considered.
3, this part recommends that you use a universal wireless charging package with usb interface.
4, can not be directly connected to the battery, because wireless charging is also the use of electromagnetic mutual inductance principle, similar to the primary and secondary transformers, the power to the mobile phone side must be AC, and then filter voltage regulation, to achieve charging function, and placedThere are absolute requirements.