2, the method of making wireless charger is as follows Making mobile phone wireless charger : Stick the module in the place where the MicroUSB interface is compared. Connect the MicroUSB or Lightning port on the module to your phone. If there is double-sided tape on the receiver Make mobile phone wireless charge , you can directly glue it to the back of the phone. If it is not attached, it is necessary to find a way to make mobile phone wireless charging. Choose the most suitable position, be careful not to let the part of the connection line have the phenomenon of warping.
3, soldering iron, copper wire, resistor, transistor, capacitor. That will do. So wireless charging is simple. But I suggest you don't do it yourself. It's all special materials. If you do it for fun, just make an oscillating circuit.
4, one of the self-woundThe coil is connected in the charging circuit, 555 output foot (the third foot) is connected to an output tube (at your own will, but to the high-frequency power tube) the output tube is linked to the self-winding coil, and the connected two coils are close (about 1 cm or so there is a very sufficient charging current). The efficiency of this circuit is very low, because there is only half a wave peak high frequency so the loss is relatively large, but the principle is quite simple and easy to produce.
1, the phone standard charger and dataConnect the wire to the wireless charger, and then put the phone in the center of the wireless charger base, you can realize wireless charging, the indicator light will have a breathing effect, 5 seconds after the extinguish, plug and play, convenient and quick.
2, can refer to the following information: the mobile phone standard charger and data cable connected to the wireless charger, and then the mobile phone is placed (vertical) or horizontally in the wireless charger base left and right center position, you can achieve wireless charging, the indicator light will have a breathing effect, 5 seconds after the extinguish, plug and play, convenient and quick.
3, operating mobile phone: vivox90 operating system: OrigiPower. Then, place the phone on the MagSafe charger with the display facing up to charge it wirelessly.
2, operating mobile phone: iPhone14plus operating system: iOS16 Apple 14plus set the steps of wireless charging as follows: We open the mobile phone and click Open Settings to enter the mobile phone setting interface. In the mobile phone setting interface, we click open the battery to enter the battery setting interface. In the battery setting interface, we click open the battery health.
3, hitOpen the phone [Settings] and click [Battery]. Click the "Wireless Charging Settings" option. Turn on the switch on the right of [Charging Silent Mode]. Expanding your knowledge: The iPhone is a line of mobile phones powered by Apple Inc. 's iOS operating system that went on sale on Jan. 9, 2007.