the process is as follows
< br >
one
< br >
Wire cutting, use the wire cutting machine to cut the cable to ensure that each cable has the same length;
< br >
two
< br >
Peeling, using pneumatic peeling machine to peel the sensor head skin and plug skin;
< br >
three
< br >
Peel the inner core, using a pneumatic peeling machine to peel the inner core of the sensing head and the inner core of the plug;
< br >
four
< br >
Punch the terminal, hold the product in the left hand, hold the terminal flat on the bottom die of the punch press with the right hand, start the punch press to connect the terminal with the cable;
< br >
five
< br >
Terminal positioning, insert the product vertically into the mold core hole, insert the mold core vertically into the mold cavity, pull the cable flat, keep the pin parallel, and perform terminal positioning injection;