In theory, it can support multiple bridging of routers. However, in practical applications, after many Bridges, the loss of wireless signal transmission is too large. Routing on the end end will be inefficient or even non-efficientCan communicate with the previous level normally. So, bridging is conditional. The specific situation is related to the actual working environment (indoor, outdoor, floor, wall, etc.), the location of the router (mutual bridging distance), and the signal strength of the external network.
Enter Application Management - Wireless Bridging again, and you can see that the bridging status is successful. As follows. At this point, the wireless bridge setup is successful.
Yes, plug in the lan port of the wireless router and disable dhcp.
solution, one is to plug the wan port of the new wireless router into the lan port of the secondary router.Wireless charger "Wireless Adapter Driver". Whether there is Wireless Connection in Network Connection. According to the above, you can click on the wireless network searched for Internet access (not explained here).
Open Network Neighbors on my computer, go to the control panel and click on it, then there is a network connection and click on Properties to see if there is a wireless card.
zcx wireless charging ring You see your computer screen in the lower right corner of the task bar there is no wireless connection icon (similar to the local connection next to a wireless transmission arcLine icon), if not very normal, the general desktop does not, because the desktop host is placed under the desk, the wireless reception signal will not be very good. You want to install a wireless card is very simple, buy a USB external LAN wireless card can be done, 30-50 yuan.
It's like if you want to know where there is a cell phone signal, you need to use your cell phone to monitor it. You have to use a laptop, or a Wifi-enabled phone, tablet or other device to detect it.
Find the wireless network switch Notebook will have a small switch to control the wireless network, do not know the friendTry looking around your computer to see if your Wi-Fi switch is on. Flick the switch Just flick the switch to go back to the wireless search. Right click on computer - Management - Services and Application Services - Services zcx Wireless charging ring ; Find "Wireless Zero Configuration" on the right and double click.