There are two possible wireless juicer does not charge , the first is the reason for the charger Wireless juicer does not charge , the charger has no voltage or no current output, you can use a multimeter to test its charging output to see if it is normal. If the charger is normal and has normal voltage and current output, it should be a battery problem. Prolonged loss of power and other conditions are not conduciveBattery maintenance. Wireless juicer can not be charged You can consider replacing a new battery, so that it can be used.
may be an internal disconnection problem, or it may not be plugged in. Check to see if the socket is plugged in the wrong way and if the plug is connected to the power supply. Or the reason is the power configurator, some are not original, the output power is relatively low, there will be no charge. In addition, you can also change a charging head to try to see if the charging head is burned.
may be a failure of the internal motherboard of the juicer or its
2, portable juicer charging Wireless juicer charging , the interface may accumulate dust or debris because of a long time of use, resulting in no charging. At this point, you can use a clean, soft cotton swab to gently clean the inside of the interface. At the same time, you should also check whether the battery is working properly. If the battery ages or liquid leaks, etc. AskProblem, may cause charging failure. It should be noted that if you do not have the relevant repair experience, it is best to entrust the battery replacement work to professional maintenance personnel.
3, the general charging juicer uses a lithium battery, when the battery is not charged, it is likely that the battery enters a dormant state, and the battery needs to be awakened. The specific measures are as follows. Open the battery package. Find where the shield connects to the battery. Charge the battery with a 5V power supply directly touching the two poles of the battery, paying attention to the correct polarity. The charging time is 5 seconds, stop 5 seconds, and charge 20 times. Measure the battery voltage if it is greater than 7V.
1, the battery may be insufficient or the charging cable is improperly connected. If the battery is insufficient, the white light flashes when charging because the battery cannot start normally. The juicer cup needs to be fully charged for normal use. When the charging cable is connected to the juice cup, if it is loose or falling off, the battery cannot be charged normally, and thus cannot be started. Therefore, checking whether the charging cable is well connected is one way to solve the problem.
2The reason why 9600 can not be charged after the battery is replaced is that the components of the juice cup control board are in contact with liquid or damp, which is easy to lead to short circuit, and the charge will not be charged, and the control board can be repaired. The plug of the juicer cup is damaged, you can replace it with a new plug. Is the juice cup motor damage, repair the motor can be.
3, the charging line contact is poor: the juice cup charging has been bright white light does not charge because the charging line contact is poor, you can reinsert the charging line. Battery failure: Juice cup battery failure, replace the battery. Circuit board failure: juice cup circuit boardIt needs to be repaired by professional maintenance personnel.
4, if the Mofei juice cup is not charged, first check whether the charging jack is inserted or damaged, and try to replace the new charging jack. Then check whether the mains socket is powered on, no power will lead to no charge. Then check whether the power line is broken, whether the motor is damaged and whether the control circuit has components burned out, and handle according to the specific situation.