The wiring method of the wireless remote control switch is as follows:
1. First, connect the power cable of the remote control switch to the power socket and ensure that the power cable is securely connected.
2. Then, connect the receiving module of the remote control switch to the power cable. Usually, there are two interfaces on the receiving module of the remote control switch, one is the interface for receiving signals, and the other is the interface for supplying power. Connect the receiving port on the receiving module to the receiving port on the power cable. Ensure that the connection is secure.
3. Next, connect the handle part of the remote control switch to the power cable. Usually, there are three interfaces on the handle part of the remote control switch, which are normally open, common end and normally closed end. Insert the common end of the handle part into the common interface on the power cable to ensure that the connection is secure.
4. Finally, plug the power cable of the remote control switch into the power socket to ensure that the power cable is securely connected.
Please note that the above is a general wiring method, the specific operation may vary depending on the remote control switch model and specification. It is recommended that you carefully read the manual of the remote control switch or consult a professional before wiring to ensure correct wiring and normal function.
Wiring method of wireless remote control switch:
< br >
Two black wires connect in parallel inside the remote control switch. A zero line is randomly selected (the black wire next to it is connected to the zero line).
< br >
Another black and blue line on the other side of the housing is connected at both ends of the load.
The wiring steps of the wireless remote control switch are as follows: First determine the two output terminals of the switch, generally COM (common terminal) and NO (regular starter).
Next, disconnect the power supply and make sure the circuit is in a safe state. Connect the power supply wire to the COM terminal, and connect the power cord of the electrical device that needs to be controlled to the NO terminal.
Then, connect the COM and NO terminals to the power supply and ensure that the wiring is secure. Finally, power it on again and test whether the remote control switch functions properly.
The wiring method of the intelligent switch is: the black two wires are connected in parallel inside the remote control switch, and one is connected to the neutral line (the black wire on the side is connected to the neutral line); The other black wire and the blue wire on the other side of the housing are respectively connected to both ends of the load. The red wire goes to the wall switch and then to the fire wire.