Please check that the back of the phone is centered in the center of the wireless charging board. When there are inclusions between the mobile phone and the wireless charging board Samsung wireless charging 2 generation can not be charged , may not be able to charge normally. Please check the back of the phone. ifThe use of Samsung wireless charging 2 generation does not go in The protective mobile phone cover is too thick may hinder wireless charging Samsung wireless charging 2 generation does not go in , it is recommended to remove the mobile phone cover and try to recharge. Please use the original Samsung charger. If you use a non-original charger, it may lead to normal charging Samsung wireless charging 2 generation can not be charged situation.
Please check that the back of the phone is centered in the center of the wireless charging board. Between the phone and the wireless charging padIf there are inclusions, it may not be able to charge properly. Please check the back of the phone. If the protective phone cover used is too thick may hinder wireless charging, it is recommended to remove the phone cover and try to recharge. Please use the original charger. If you use a non-original charger, you may not be able to charge normally.
If your mobile phone can not use wireless charging, please follow the following steps to check the Samsung wireless charging 2 generation is not charged : Check whether the phone is overheating, it is recommended to charge in a good heat dissipation environment. Check whether the wireless charger indicator light is on normally and check at the same timeIf the connection between the charging base, data cable, charger, and power supply is not in good contact, it is recommended to reinsert it.
This condition is usually caused by the fault of the phone charger. If the actual output voltage of the mobile phone charger is lower than the rated output voltage, then during the charging process, when the battery voltage of the mobile phone rises to a certain value, but does not fully charge the battery, the current voltage of the mobile phone battery is consistent with the output voltage of the charger, so there is no voltageThe difference will cause the charge to stop. It is recommended to replace the charger for testing.
Check whether the original charger is used. If not, please replace the original charger and try again. Try replacing another power socket. If the battery can be removed, reinstall the battery or replace it with another original battery and charge it again. Update the mobile system version: Settings - About the phone (about the device) - manual download updates/automatic download updates (software update/System update - Update). Note: Back up the data on the device before the upgrade.
Cell phone battery problem. Check your phone's battery level Steps: Open Settings on your phone. inTap Battery in Settings. On the Battery screen, tap Battery Health. Turn off the optimized battery charging function in Battery Health, and then re-charge wirelessly.
Wireless charging is not mature, it is like the previous black and white TV, the signal is not good, take two normal. But wireless charging can not see the radio wave, this can only be taken to the expert to see.
Hello, if you use a wireless charger, there is always an intermittent charging prompt tone, it should be that the back of your phone is not accurately placed on the wireless charging contact surface, and it may be that your phone case affects wireless charging, you can remove the handCharger does not respond
1, use the original charger and data cable to connect the power supply to charge. For mobile phones with removable batteries, you can shut down and remove the battery, use a cotton swab to clean the battery contact and try the phone charging interface. If the above method does not solve the problem, please bring the purchase invoice, repair card and the machine to the Samsung service center for inspection.
2, please check whether the back center of the phone is placed in the center of the wireless charging board. When there are inclusions between the mobile phone and the wireless charging pad, it may not be able to charge normally. Please check the back of the phone. Using a protective phone case that is too thick may hinder wireless charging, buildDiscuss removing the mobile phone cover and re-charging attempt. Please use the original Samsung charger. If you use a non-original charger, you may not be able to charge normally.
3, use the original charger to connect to the home power supply. Replace the power socket Try or replace a data cable with a charger to charge. If the phone can be turned on normally, you are advised to back up data (such as contacts and multimedia files) on the phone and restore the phone to factory Settings. If the problem still exists according to the above methods, please bring the purchase invoice, repair card and machine to the nearest service center for inspection.