Check your urv wireless charge supports wireless charging. If you are unsure, refer to your vehicle manual or contact your car manufacturer. Place the smart phone that supports the wireless charging function urv wireless charging or its urv wireless charging other device in the wireless charging area of UR-Vurv wireless charging . Typically, this area is located in the central console or in a storage bin between the front seats. Make sure your device is properly placed and aligned with the charging area.
ChargeElectrically, it has a power of 20w. First, make sure he gets the green light. Second, your phone should support wireless charging. And then put the phone right. If you put your phone in the wrong place, this panel will beep.
When the wireless charging function of your URV vehicle flashes a red light, it is likely to be caused by an overtemperature fault. If you encounter this problem, it is recommended that you immediately call the after-sales phone to inform the situation, in order to get a timely solution. Wireless charging technology comes from radio energy transmission technology, which can be divided into two ways: low-power wireless charging and high-power wireless charging.
Fix the car wireless charger to the right place in the cab and put the phone on it. If the phone case is too thick or not the original charging case, it may affect the charging effect, it is recommended to take off the case and try charging.It has a power of 20w when charged. First of all, ensure that the urv wireless charge he this key to the green light. Second, your phone should support wireless charging. And then put the phone right. If you put your phone in the wrong place, this panel will beep.
The Honda urv has a usb port, which is the charger. On the urvUSB interface function: Insert U disk to listen to songs. The phone is charged. There are many functions, but with too many appliances, the load is too large urv wireless charging Damage to the battery and generator, more than worth the loss.
1, if charging, its power is 20w. First, make sure he gets the green light. Secondly, your mobile phone should supportWireless charging function. And then put the phone right. If you put your phone in the wrong place, this panel will beep.
2, the use of urv wireless charging is as follows: Check whether your UR-V supports wireless charging function. If you are unsure, refer to your vehicle manual or contact your car manufacturer. Place a smartphone or other device that supports wireless charging in the UR-V's wireless charging area. Typically, this area is located in the central console or in a storage bin between the front seats. Make sure your device is properly placed and aligned with the charging area.
3, Honda CRV wireless charging powerThe use of the energy is as follows: Fix the car wireless charger in the appropriate position in the cab. Connect one end of the USB data cable of the wireless charger to the car cigarette port and the other end to the wireless charger. Put your phone on and charge it.
4, the car wireless charging does not go in, may be the car wireless charging charging system failure. Or it's wireless charging in the car. No charging system connected. Wireless charging board problem: When the mobile phone is placed on the wireless charging board, the wireless charging will automatically charge the mobile phone, if the wireless charging board fails, there will be an alarm phenomenon that the mobile phone is charged for a while. Work outSolution: Replace the wireless charging board.
5, first of all, the car wireless charger is placed in the appropriate position in the cab to ensure its stability. Then, connect one end of the USB data cable of the wireless charger to the cigarette lighter interface of the car, and connect the other end to the wireless charger itself. Finally, place the phone on the wireless charger, making sure the phone is aligned with the charger and in good contact, and you can start charging.
6, the use of the car with wireless charging: the car wireless charger fixed to the appropriate position in the cab, the wireless charger data cable connector connected to the car's cigarette lighter interfaceUp; The other end is connected to the wireless charger, and after fixing the wireless charger, ensure that the wireless charger will not slip off and can be used normally.
Car wireless charging does not go in, it may be that the charging system of car wireless charging fails. Or it's wireless charging in the car. No charging system connected. Wireless charging board problem: When the phone is placed on the wireless charging board, the wireless charging will automatically charge the phone, if the wireless chargingIf the board fails, the phone will be charged for a while and the alarm will be reported. Solution: Replace the wireless charging pad.
【 Pacific Auto network 】 The charger converter is damaged, can not be converted and charged, replace the charger resistor. Battery welding, check with a multimeter. Charger insurance burned out, replace the charger. If the power cable is disconnected or in poor contact with the battery socket, replace it.
The reasons and solutions for the flashing red light of the charger are as follows: The converter of the charger is damaged, cannot be converted and charged, and the charger resistor needs to be replaced. Use a multimeter to check whether the battery is welded. If yes, replace itBatteries. Charger insurance burned out, need to replace the charger. The power cable is disconnected from the battery socket and is in poor contact with the battery socket. Replace the power cable to ensure that it is tightly connected to the battery socket.
Fix the car wireless charger to the right place in the cab, and then put the phone on it. If the phone case is too thick or not the original charging case, it may affect the charging effect, it is recommended to take off the case and try charging.
Personal testing is OK, as long as there is no praiseThe mobile phone cover decorated by Zhang can be filled directly, otherwise what convenience can be talked about.
Generally does not affect, the thickness of the phone case is generally 1mm, which is acceptable in wireless charging, the phone case is generally plastic, it will not affect the charging induction, as long as it does not have metal or other conductive materials.
Fixed wireless charger. The owner needs to buy a suitable wireless charger equipment, and then fix the wireless charger on the vehicle, and the fixed position should be convenient for the owner to take. Connect the cigarette lighter. One end of the USB data cable of the wireless charging device is connected to the wireless charger and the other end is connectedConnect the car cigarette lighter interface. Put it in your phone. Put your phone in a wireless charger and it will start charging.