If yes, signal reception will be affected. Because there are two black lines on each side of the Apple phone body wireless glue , and they are symmetrical.
will not affect wireless glue Wireless glue , just replace the wireless glue Screen, without moving other components can be wireless glue . Note, first of all, it is best to repair the phone is authorized Apple after-sales network, so that the maintenance will be more guaranteed. Once again, it is recommended to do a full range of testing after repairing the phone, and pay again if there is no problem.
Apple customer service has remotely checked that the hardware is fine. Solution: The iPhone 12 wireless charging failure, often not charged into the charger may be caused by incompatible.
Wearing the original protective case can better protect the mobile phone, will not cause adverse effects on the mobile phone. ifThe use of metal protective cases may affect the reception of mobile phones.
First remove the clinker cushion of the free light wireless charger. Next, unscrew the four screws. Finally unplug the power plug wireless charging glue , you can take off the wireless charger.
Observe the fixing method of the mobile phone stand, there are screws, clasps or its wireless glue He fixed device, use the corresponding screwdriver or wrench, reverseTurn the screws clockwise and remove them one by one. Once the fixture is removed, the parts of the bracket can be gently separated.
First confirm whether the nightstand wireless charging is normal. Determine whether wireless charging mode is enabled on your phone. If it doesn't work, restart the phone and put it in again.
1, the bottom of the wireless charger is a rubber ring non-slip wireless glue , after removing the rubber ring to reveal 6 fixing screws. oneTotal 6 screw holes. Unscrew the fixing screw Wireless charging glue and turn on the wireless charging. In the middle of wireless charging is a wireless charging coil, and in the middle of the coil is a thermistor temperature measurement. The wireless charging board is relatively simple, with only two main ics. A large iron sheet on the back for heat dissipation and counterweight. Above the iron sheet are thermal silicone, magnetic insulation, coil.
2, with color silicone protective film can be used in two ways, ① the use of color PET original film. ② Add color paste in the coating liquid silicone glue, the current double PET silicone film on the market: blue, red,Transparent ones are more common.
3, first of all wireless glue ; Wireless filling glue We need to prepare, special silicone, curing liquid, mixing box, syringe, and nano fingerprint film model glue. The first step; The hot air of the hair dryer is heated to soften the nano fingerprint model glue. After the nano fingerprint model glue is softened, the finger is pressed horizontally and vertically on the nano fingerprint model glue to form a fingerprint groove of 0.2 to 0.3 cm. The finger is pulled away after the nano fingerprint model glue is completely hardened.
<