1. Prepare the required raw materials and tools (wireless plug board, plug, wire, screwdriver), the quality of these raw materials can be selected better, and the wire can be purchased according to its own needs.
2. Connect the plug first. Peel off one end of the wire to reveal two metal wires. Use a screwdriver to remove the protective cover of the plug and loosen the wiring screws on the metal plate of the plug.
3. Wrap the two peeled metal wires around the two metal sheets of the plug, and then tighten the connecting screws. Then put the plug protection case in place, screw on the screw, and the plug is installed.
4. Connect the board. Also peel the other end of the wire to leak out two metal wires, remove the plug board with a screwdriver, you can see the red line (live line) and green line (zero line) inside, there is a wire do not care about it, the red line and green line is used to connect the line.
5. Loosen the cable screws on the red and green wires, wrap the two peeled metal wires around the cable screws, and tighten the cable screws.
6. Finally, install the protective shell of the insert board, screw on the back, and a insert board that can meet your needs is born. Then connect the power supply to test whether it can be used normally.