The procedure for assembling a wooden sketch easel is as follows:
1. Prepare all the components of the wooden sketch easel, including the columns, cross bars, and brackets.
2. First place the column on the ground, and place the column spacing properly according to the design of the easel.
3. Place the bar on the column and determine the position of each bar.
4. Install the strut onto the bar and fix the strut and bar together by turning the screws.
5. Ensure that each component is securely installed and adjust the height and Angle of the easel as necessary.
6. Perform a final check to ensure that all easel components are securely installed. 7. After completion, try to place the easel on a flat and stable ground to provide good support and stability. 8. Check that the easel is vertical and can be stably supported and adjusted to the required Angle.
The above is the basic steps to assemble the sketch wooden easel, the specific assembly process may vary by brand and model of easel, you can refer to the relevant assembly instructions or consult the seller for more detailed assembly guidance.
Sketch support installation method is as follows
1. Install the bottom bracket with eyes (metal) to the legs of the two screws;
2. Open the fixed shelf of the top pull rod, pull the upper pull rod apart, and insert the pull rod into the back of the bottom bracket;
Third, open the clamp at the top of the pull rod, adjust the height according to the size of your drawing board, clamp and lock. ;
4. If there is a strap, pull it up and secure it to the back leg