Steps are as follows.
< br >
1. First replace the low matching reading light;
< br >
2. Removed low matching lamp;
< br >
3. Wiring test;
< br >
4. To open the hole in the back row, you can use a paper knife, measure the position and then open, not too hard;
< br >
5. After opening the hole is the lead, the lead is a technical work, spent a lot of time, in the darker position there is an iron plate blocking, so be very careful;
< br >
6. Test whether the rear light works normally;
< br >
7. The seller has a plug to take electricity, so there is no need to break the line, the next is to fix the line, do not let it produce abnormal;
< br >
8. Then down began to fix the back lights, the boss with a bayonet panel, and glue, glue, with a clamp fixed for half an hour, after that, you can install it;
< br >
9. Done, the next step is to turn on the trunk light and trunk. Install the door first;
< br >
10. Install and wire the tailbox motor at the same time;
< br >
11. Because you want to receive electricity from the safety box, you should pull to the main driving position to get electricity from the safety box;
< br >
12. Connect the power test switch.