Tools: tape, screwdriver, wire pliers, rubber pry knife, traction wire
< br >
1, the original accessory camera wiring harness into the rear license plate light drilling, and then directly into the card;
2. Remove the liner of the trunk, pull out the waterproof cable ring, use the traction wire to pull out the camera harness to the trunk, lead the camera harness and data connector to the cable hole of the rubber ring, and finally install the waterproof rubber ring;
3. Remove the decorative lining board on the left side of the trunk, connect the data power extension cable with the camera wiring harness, and lead out from the rear trim board along the original car wiring harness;
4. Open the sealing rubber strip on the left side of the door of the back seat, pull the cable into the back seat cabin, and pull out the integrated plug of the data power supply and the remaining extension cable;
5, restore the trunk, the extension line along the door of the rubber strip into the plastic plate gap, until the cockpit door;
6. Remove the storage box under the headlight, pass over the OBD interface, and then connect the wiring port with the navigator interface.