Hello, if the speaker cable is broken, you can follow the following steps to repair:
1. Confirm the position of the breakpoint: First, confirm the position of the disconnection of the cable, which can be determined by checking the connectors at both ends of the cable or directly looking for the crack or fracture on the cable.
2. Cut off the breakpoint: Use scissors or a blade to cut off the damaged parts on both sides of the breakpoint.
3. Strip the insulation layer of the row wires: Use a wire stripper to strip the insulation layer at both ends of the row wires to expose a certain length of metal wires.
4. Connect the cable: Insert the metal wires at both ends of the cable into the connector or connect them using a connector to ensure that the connection is tight.
5. Test: After completing the cable connection, you can test by connecting the audio device to ensure that the speaker can work normally.
It should be noted that the hands should be kept dry when maintaining the speaker line to avoid short circuit or damage due to moisture. At the same time, the wiring connection should be firm and reliable to avoid problems such as loosening or poor contact.
The speaker cable is broken, and the following maintenance steps are required:
< br >
1. Determine the position of the broken line: First remove the protective cover of the speaker, observe the line, and determine the position of the broken line.
< br >
2. Clean the broken line: Clean the broken line with alcohol or needle to ensure that the connection surface is free of dirt and oil.
< br >
3. Remove the broken wire: Use wire strippers or scissors to remove the insulation layer at the broken wire, exposing the internal wire.
< br >
4. Insert the wire into the plug: If the broken wire is a plug, insert the wire into the plug and connect the wire according to the pin connection of the plug.
< br >
5. Wiring: If the broken wire is not the plug, the wire is wired according to the original connection method.
< br >
6. Test: After connecting the wire, test whether the speaker works normally.
< br >
7. Fix: Tape or weld the connected wire.
< br >
8. Installation: Install the shield back and test whether the speaker works properly.
< br >
The above is the maintenance method of the speaker line broken, it should be noted that in the maintenance process to be careful to avoid causing greater damage to the speaker.
For this issue, to fix the disconnected speaker cable, follow these steps:
1. Confirm the disconnection position: Check whether both ends of the speaker bar are properly connected. If only one end is disconnected, find the disconnection position.
2. Peel off the outer skin: Use a wire stripper or scissors to peel off the outer skin of the wire to expose the internal wire.
3. Clean the wire: Use a clean cloth or cotton swab to wipe the dust and dirt on the wire.
4. Insert the cable connector: Insert the cable connector into the cable port and ensure that it is tightly connected.
5. Fix the cable connector: Use a pair of pliers or wrench to fix the cable connector on the wire and ensure that the connection is secure.
6. Test the connection: Plug in the audio device and test whether the connection is normal.
If you are unsure of what to do, seek professional help.
1. Peel off the two parts with wire strippers respectively.
2, and then put the corresponding heat beam tube on one side of the cable.
3, the two lines are wrapped together correspondingly, and then welded with an electric soldering iron, pay attention to the smooth solder joints.
4, the heat beam tube just set in the welding position, and then use a lighter to roast it properly, or blow it with a hot air gun.
5, try to put on the stereo to see if it can work normally.
The speaker line is broken, you need to buy a replacement of the same model, you can also go to the mobile phone repair shop to find professional maintenance