In the user of this wireless charging device, the wireless charging bracket must be installed first, but its installation is very simple, it is divided into three parts, base, support rod, mobile phone platform three parts, installation according to the instructions first install the base, install the support rod and finally install the mobile phone platform, debug the stable Angle on the line. This is to take out the link cable of the Android usb bracket and connect the usb interface of the bracket to the usb interface of the car or other adapters, but it is necessary to ensure that the working voltage is 12v~15v, too high or too low may lead to normal charging or affect the effectiveness of charging. After connecting the usb, you can see that the power display on the bracket is on. Indicates that this is the support can be used normally;
At this time, install the patch installation operation manual on the back cover of the Android phone, and then put the phone on the bracket, which is that as long as the phone is close to the bracket, it will automatically extend the bayonet, you put the phone belt and the patch together on the top, when you see the phone is charging, it is normal;
If it does not show that the phone is charging, this is the position of the phone and the patch under the up and down adjustment, it is OK. This is the need to turn the position of the lower bracket Angle, adjust the phone to facilitate your eyes on the line.
3, then turn on the wireless reverse charging switch