1, of course, the first is to disassemble the whole machine, before you are ready to use the corresponding screwdriver.
2. When removing the screen, gently separate the small chip connected to the motherboard from the motherboard.
3. Tear off the card slot sticker under the access card and the access card before removing the metal shield isolation layer.
4, finally is to take the hair dryer dry, but do not blow on the screen for a long time, such high temperature will destroy the screen, even if the screen has a watermark can also use the phone normally, the water in the screen will generally dry in two days, you will see the watermark inside is getting smaller and smaller.
5, the motherboard on both sides of the good blow to ensure that there is no moisture residue, the phone and the keys to try to blow out the water.
6. Finally, put the dismantled mobile phone in a dry and noisy place, it is best to place it for about two days, and then install it.
How to deal with water in Bluetooth headset? Below, let's take a look at the 3 ways to deal with water in Bluetooth headphones!
< br >
< br >
Method 1:
< br >
Hair dryer method: This method can be said to be the most direct violence, because the Bluetooth headset is small, of course, if the water situation is also serious, using a hair dryer to blow directly on the machine, usually after a period of time can be repaired, but need to control the temperature.
< br >
Method 2:
< br >
Place method: Drain the water of the earphone and put the earphone into the rice jar with a vacuum belt, so that it can be placed for a few days.
< br >
Method 3:
< br >
Maintenance method: This method will lose the risk of warranty, it is recommended that users use after the warranty, directly disassemble and dry with hot air, of course, you need to pay attention to the loss of this component.
Bluetooth headset is very small, of course, if the water is also very serious, with a hair dryer directly to the machine, generally after a period of time can be repaired, but need to control the temperature.
2. Placement method
Drain the water out of the earphones. Use a vacuum strap to put the earphones in a rice jar and leave them for a few days to drain the water out.
3, maintenance methods
This method will lose the risk of warranty. It is recommended that users use it after passing through the warranty channel, disassemble it directly and dry it with hot air. The loss of this component should certainly be noted.