operational approach
one
Step 1: After the pure electric vehicle is powered off, open the charging port cover, and the charging indicator light on the motor tachometer is lit. At this point, the vehicle will not travel when it hits \"ON\" gear.
During the charging process, the charging indicator in the motor tachometer is always on. Only after unplugging the charging plug and closing the charging door, the charging indicator will be extinguished.
two
Step 2: Connect the charging plug to the charging socket on the vehicle.
< br >
three
Step 3: Connect the other end of the charging plug to the charging socket on the charging pile. After swiping the card, the car charger will start charging the power battery pack. Or plug your home plug into A 220 V\/16 A outlet for charging.
< br >
four
To charge a very low power battery pack to full charge, it generally takes 7h to use 220 V AC. The length of the charging time also depends on the state of charge (SoC) of the power battery pack, which is shorter when the state of charge is higher and longer when the state of charge is lower.
To check whether the power battery pack is fully charged during the charging process, just hit the key to the \"ACC\" or \"ON\" stop, which can be read from the dashboard.
When the pointer indicates 100%, it indicates that the power battery pack is fully charged. When the pointer does not indicate near 100%, it indicates that the power battery pack has not been fully charged.
The six steps are: divided into physical connection, low-voltage auxiliary power-on, charging handshake, charging parameter configuration, charging, charging end; Electric vehicle charging methods a total of slow charge, fast charge, power change, wireless charging and mobile charging, but the vast majority of electric vehicles on the market only support slow charge and fast charge, and are equipped with slow charge and fast charge interface, other charging methods have not been widely used.
The charging steps are:
1. Turn off the engine; 2, take out a positive and negative pole of the cable; 3. Remove the card to open the battery protection cover and expose the positive and negative terminals of the battery; 4, take a cable, one end of the battery is connected to the positive electrode, the other end is connected to the positive electrode of the battery; 5, take the other end of the wire, connect the battery negative, and then connect the other end to the engine housing or body of the electric vehicle, remember that the negative is connected to the negative; 6. Start the car with electricity.